For the time being I only have two modules but plan to add more at a later date to create a mesh network so the series 2 modules are better suited for the job.Īll I want to do/know is how to set up the XBee module as a coordinator, if it's possible to do this without firmware updates and also if I need to update the firmware, is there is an application for Mac OS X that will allow me to do so? And finally, can all of the above be done without an XBee explorer and instead just using an arduino and an xbee shield?Īny help would be greatly appreciated as I'm currently feeling a little out of my depth and rather peeved that I can't seem to find any alternative applications for Mac OS X. I realise that XBee series 1 modules are much easier to setup, although I have no prior experience. Each download we provide is subject to periodical scanning, but we strongly recommend you check the package for viruses on your side before running the installation. The version of CoolTerm for Mac you are about to download is 1.9.1.3. ![]() ![]() I've seen that this is possible through X-CTU but am wondering if there is any way to do this in Mac OS X with the right application? The contents of the download are original and were not modified in any way. My question is how can I set up an XBee module as a coordinator?įrom what I can gather (and I hope this isn't the case) I need to update the firmware for the required module to be the Coordinator firmware rather than router/end point firmware which I think is currently installed on both modules. devices such as modems, routers, embedded uC systems, GSM phones. Next i was on the hunt to find something that i could actually use with the freshly installed adapter. CoolTerm seems to offer most of the functionality of X-CTU so i've been able to progress so far but am now stuck. Here are the top 15 coolterm alternative and similar softwares as derived from our. ![]() I've seen plenty of reference to X-CTU for windows but am unable to run this myself seeing i'm using Mac OS X. I'm using Mac OS X and have been able to use an application called CoolTerm.app to configure my XBee modules so far. I recently purchased 2x XBee Pro Series 2 modules and am having trouble finding information on how to set up one XBee module as a coordinator. CoolTerm is described as 'simple serial port terminal application (no terminal emulation) that is geared towards hobbyists and professionals with a need to exchange data with hardware connected to serial ports such as servo controllers, robotic kits, GPS receivers, microcontrollers, etc' and is a terminal emulator in the os & utilities category.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |